TEL:(86) 511 8443 6131
Home | Products | Products Finder | About Us | Resource Center | Contact Us
  RF Coaxial Connectors
  1.85mm Connector
  2.4mm Connector
  2.92mm Connector
  7/16 connector
  BNC/RPBNC Connector
  MCX Connector
  MMCX Connector
  N-Type Connector
  SMA & RPSMA Connector
  SMP Connector
  SMB Connector
  SSMA Connector
  TNC & RPTNC Connector
  TNCA Connector
  RF Coaxial Adapters
  RF Cable Assembly
  RF Coaxial Termination
  RF Surge Arrestor
  RF Coaxial Cable
Home > Products > Connector Install Tools
Threaded in Connector Install Tools [P/N: TCT]
Generally threaded in Connectors always choose side milling and use wrench to tighte, this install
metho's question is the wrench easy to slip and that will damage the thread. Our Threaded in

Connector has no side milling and use special install tools to solve the problem.

     Step 1: Screw the Ejector Threaded Rod into the Sleeve, adjust the appropriate depth, then screw
the Connector into the Sleeve from the other side.


  Step 2: Screw the Connector into the Shell, use wrench screw the Sleeve to tighten the Connector.
Fix the Sleeve, use another wrench screw the Ejector Threaded Rod opposite direction to loose it,
then take it down with the Sleeve together.



P/N: TCT (Include Ejector Threaded Rod and Sleeve)

 Threaded in Connector Install Tools [PDF] 


  Recommended Products:
Home | About us | Contact us | Disclaimer | Privacy Policy | Site Map | Cmpter Electronics Co., Ltd.
Tel:(86)511 8443 6131 Fax:(86)511 8717 7136
Copyright © Cmpter Electronics 2013